华为机顶盒卡logo了，强刷刷不进去，备份的系统用HITOOL也刷不进去，哪个大神看看是怎么回事
Bootrom start
Boot from eMMC
Starting fastboot ...
System startup
DDRS
Reg Version: v1.1.0
Reg Time: 10/25/2014 8:34:16 Phi3798mdmo1d_hi3798mv100_ddr3_2gbyte_8bitx4_4layers_emmc.reg
Reg Name: hi3798mdmo1d_hi3798mv100_ddr3_2gbyte_8bitx4_4layers_emmc.reg
Jump to DDR
Fastboot 3.3.0-01226-g22e9717-dirty (mojiníing@HW-TV-S3) (Nov 29 2015 - 10:14:04)
Fastboot: Version 3.3.0
Build Date: Nov 29 2015, 10:14:57
CPU: Hi3798Mv100
Boot Media: eMMC
DDR Size: 1GB
Check nand flash controller v610. found
Special NAND id table Version 1.36
Nand ID: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
No NAND device found!!!
MMC/SD controller initialization.
MMC/SD Card:
MID: 0x11
Read Block: 512 Bytes
Write Block: 512 Bytes
Chip Size: 3776M Bytes (High Capacity)
Name: "004GE"
Cèip Type: MMC
Version: 5.0
Speed: 52000000Hz
Bus Width: 8bit
Boot Addr: 0 Bytes
*** Warning - bad CRC or eMMC, using default environment
Boot Env on eMMC
Env Offset: 0x00100000
Env Size: 0x00010000
Env Range: 0x00010000
HI_OTP_LockIdWord,327: ID_WORD have already been locked
SDK Version: HiSTBAndroidV600R001C00SPC062_v2015091617
get key value 0x0
HI_Flash_Rmad Ret= 3072
HI_Flash_Read Ret= 3072
HI_Flash_Read Ret= 10485760
HI_Flash_Read Ret= 10485760
******** boot from kernel...********
bootargs = coherent_pool=2M console=ttyAMA0,115200 blkdevparts=mmcblk0:1M(fastboot),4M(bootargs),16M(recovery),1M(deviceinfo),4M(baseparam),4M(pqparam),4M(logo),16M(fastplay),8M(misc),24M(factory),12M(kernel),8M(iptv_data),340M(backup),340M(cache),520M(system),-(userdata)HI_Flash_Read Ret= 512
HI_Flash_Read Ret= 512
Stb mac is : [00:21:26:40:72:A6]
Reserve Memory
Starô Addr: 0x3FFFE000
Bound Addr: 0x8D3B000
Free Addr: 0x3EDC9000
Allc Block: Addr Size
0x3FBFD000 4194304
0x3F8FC000 3145728
0x3F8F9000 8192
0x3F8C4000 212992
0x3F7C3000 1048576
0x3F7BF000 12288
0x3F43A000 3686400
0x3F2A4000 1658880
0x3EF1F000 3686400
0x3EDCC000 1384448
0x3EDC9000 8192
Press Ctrl+C to stop autoboot
kernel @ 3e08000 (7848936 bytes)
ramdisk @ 4e00000 (329507 bytes)
page size @ 2048 bytes
^+Érd_ótart = 4e00000,rd_end = 4e50723
## Booting kernel from Legacy Image at 01ffc7c0 ...
Image Name: Linux-3.10.0_s40
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 7848872 Bytes = 7.5 MiB
Loal Address: 02000000
Entry Point: 02000000
load:2000000,blob_start:1ffc7c0,blob_end:2778ba8,image_startz1ffc800,image_len:77c3a8
Loading Kernel Image ... OK
OK
kernel loaded at 0x02000000, end = 0x0277c3a8
images.os.start = 0x1FFC7C0, images.os.end = 0x2778ba8
images.os.load = 0x2000000, load_end = 0x277c3a8
ret -2
initrd rd_start = 4e00000,rd_end = 4e50723
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Booting Linux on physical CPU 0x0
Linux version 3.10.0_s40 (root@HW-TV-S3) (gcc version 4.4.1 (Hisilicon_v200(gcc4.4-290+glibc-2.11+eabi+nptl)) ) #1 SMP Sat Aug 6 16:21:28 CST 2016
CPU: ARMv7 Processor [410fc075] revision 5 (ARMv7), cr=10c53c7d
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine: bigfish
cma: CMA: reserved 380 MiB at 27000000
cma: CMA: reserved 4 MiB at 3fc00000
Memory policy: ECC disabled, Data cache writealloc
CPU: Hi3798Mv100
PERCPU: Embedded 8 pages/cpu @81a96000 s12224 r8192 d12352 u32768
Built 1 zonelists in Zone order, mobility grouping on. Tota| pages: 260096
Kernel command line: coherent_pool=2M console=ttyAMA0,115200 blkdevparts=mmcblk0:1M(fastboot),4M(bootargs),16M(recovery),1M(deviceinfo),4M(baseparam),4M(pqparam),4M(logo),16M(fastplay),8M(misc),24M(factory),12M(kernel),8M(iptv_data),340M(backup),340M(cache),520M(system),-(userdata) mem=1G mmz=ddr,0,0,380M
PID hash table entries: 4096 (order: 2, 16384 bytes)
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Memory: 1024MB = 1024MB total
Memory: 620876k/620876k available, 427700k reserved, 0K highmem
Virtual kernel memory layout:
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
vmalloc : 0xc0800000 - 0xff000000 (1000 MB)
lowmem : 0x8p000000 - 0xc0000000 (1024 MB)
pkmap : 0x7fe00000 - 0x80000000 ( 2 MB)
module?ÒÂýfpp0000 - 0x7fe00p00 ( 14 MB)
.text : 0x80008000 - 0x80ee925c (15237°kB)
.init : 0x80eea000 - 0x80f5afc0 (`452 kB)
.data : 0x80f5c000 - 0x810a6d48 (1324 kB)
.bss : 0x810a6d48 - 0x8128f09c (1953 kB)
SLUB: HWalign=64, Order}0-3, MinObjects=0, CPUs=4, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:192
sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956ms
Console: colour dummy device 80x3p
Calibrcting delay lop... 2383.87 BogoMIPS (lpj=1191936)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
ftrace: allocating 33145 entries in 98 pages
CPU0: thread -1, cpu 0, socket 0, mpidr 80000000
Setting up static identity map for 0x80b2c928 - 0x80b2c980
CPU1: thread -1, cpu`1, socket 0, mpidr 80000001
CPU2: thread -1, cpu 2, socket 0, mpidr 80000002
CPU3: thread -1, cpu 3, socket 0, mpidr 80000003
Brought up 4 CPUs
SMP: Total of 4 processors activated (9572.35 BogoMIPS).
CPU:`All CPU(s) started in SVC mode.
[81 ERROR-HI_PQ]:DRV_PQ_GetFlashPqBin[2968]:PQ bin param may not burned
[81 ERROR-HI_PQ]:HI_DRV_PQ_Init[245]:Load PQB~
2
¥±
[97 ERROR-Invalid]:MCE_Init[2135]:ERR: get PDM Param
NET: Registerçd protocol family 16
DMAz preallocated 2048 KiB pool for atomic coherent allocations
hw-breakpoint: found 5 (+1 reserved) breakpoint and 4 watchpoint registers.
hw-breakpoint: maximum watchpoint size is 8 bytes.
Serial: AMBA PL011 UART driver
uart:0: |tyAMA0 at MMIO 0xf8b00000 (irq = 81) is a PL011 rev2
console [ttyAMA0] enabled
uart:1: ttyAMA1 at MMIO 0xf8006000 (irq = 82) is a PL011 rev2
uart:2: ttyAMA2 at MMIO 0xf8b02000 (irq = 83) is a PL011 rev2
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usb÷s
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Linux video capture interface: v2.00
Advanced Linux Sound Architecture Driver Initialized.
Bluetooth: Core ver 2.q6
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP socket layer initialized
Bluetooth: SCO soãket layer initialized
Switching to clocksource timer3
NET: Registered protocol family 2
TCP ûÑ
±¥Í¡hash table entries: 81y2 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 4, 67536 bytes)
TCP: Hash tables gonfigured (established 8192 bind 8192)
TCP: reno registered
UDP hash table entries: 512 (order: 2, 16384 bytes)
UDP-Lite hash table entries: 512 (order: 2, 16384 bytes)
NET: Registered protocol family 1
RPC: Registered named UNIX socket transport module.
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
Trying to unpack rootfs image as initramfs...
Freeing initrd memor{: 320K (84e00000 - 84e50000)
NetWinder Floating Point Emulator V0.97 (double precision)
CPU PMU: probing PMU on CPU 0
hw perfevents: enabled with ARMv7 Cortex-A7 PMU driver, 5 counters available
VFS: Disk quotas dquot_6.5.2
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
squashfs: version 4.0 (2009/01/31) Phillip Lougher
jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
fuîYZ¹¥Ñ(API version 7.22)
msgmni has been set to 1981
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)
io scheduler noop registered
io scheduler deadline registered (default)
io scheduler cfq registered
brd: module lïaded
loop: module loaded
input: Hi keyboard as /de~ices/virtual/input/input0
input: Hi mouse as /devices/virtual/input/input1
input: qwerty as /devices/virtual/input/input2
Hi Android vinput driver init successful!
Found Nand Flash Controller V610.
Nand ID: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
No NAND device found
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
libphy: himii: probed
Up port phy at 0x01 is connect
libphy: PHY himii:1f not found
PPP generic driver version 2.4.2
PPP BSD Compression module registered
PPP Deflate Compression module registered
PPP MPPE Compression mdule reçistered
NET: Registered protocol family 24
usbotg: usb otg driver registeredusbcore: registered new interface driver cdc_wdm
usbcore: registered new interface driver usb-storage
usbcore: registered new interface driver usbserial
usbcore: registered new interface driver option
usbserial: USB Serial support registered for GSM modem (1-port)
dwc_otg: version 3.00a 10-AUG-2012
Core Release: 3.10a
Setting default values for core params
WARN::dwc_otg_core_reset:5176: dwc_otg_core_reset() HANG! Soft Reset GRSTCTL=80000001
WARN::dwc_otg_core_reset:5176: dwc_otg_core_reset() HANG! Soft Reset GRSTCTL=80000001
Using Buffer DMA mode
|
网站导航
发表于 2022-3-5 17:16
收藏
淘帖
顶一个
踩
提升卡
置顶卡
变色卡
千斤顶
楼主
znds.com 