- UID
- 3462416
- 性别
- 保密
- 注册时间
- 2015-11-20
- 威望
-
- 金币
-
- Z币
-
- 听众
|
本帖最后由 山阴路的夏天 于 2018-3-7 17:04 编辑
求大神看看ttl刷移动磨百盒cm101s-2跑完后没法输命令显示是这。hiusb-ehci hiusb-ehci.1: irq 94, io mem 0xf9930000hiusb-ehci hiusb-ehci.1: USB 0.0 started, EHCI 1.00
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
hiusb-ohci hiusb-ohci.0: HIUSB OHCI
hiusb-ohci hiusb-ohci.0: new USB bus registered, assigned bus number 3
hiusb-ohci hiusb-ohci.0: irq 99, io mem 0xf9880000
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
hiusb-ohci hiusb-ohci.1: HIUSB OHCI
hiusb-ohci hiusb-ohci.1: new USB bus registered, assigned bus number 4
hiusb-ohci hiusb-ohci.1: irq 95, io mem 0xf9920000
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 1 port detected
rtk_btusb: Realtek Bluetooth USB driver module init, version 3.0
rtk_btusb: Register usb char device interface for BT driver
usbcore: registered new interface driver rtk_btusb
tntfs: module license 'Commercial. For support emAIl ntfs-support@tuxera.com.' taints kernel.
Disabling lock debugging due to kernel taint
Tuxera NTFS driver 3015.1.29.1.1 [Flags: R/W MODULE].
usb 1-2: new high-speed USB device number 2 using hiusb-ehci
create enforce
init: untracked pid 1627 exited
init: untracked pid 1646 exited
init: untracked pid 1626 exited
warning: `zygote' uses 32-bit capabilities (legacy support in use)
lowmemorykiller: lowmem_shrink: convert oom_adj to oom_score_adj:
lowmemorykiller: oom_adj 0 => oom_score_adj 0
lowmemorykiller: oom_adj 1 => oom_score_adj 58
lowmemorykiller: oom_adj 2 => oom_score_adj 117
lowmemorykiller: oom_adj 3 => oom_score_adj 176
lowmemorykiller: oom_adj 9 => oom_score_adj 529
lowmemorykiller: oom_adj 15 => oom_score_adj 1000
IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
binder: 1402:1402 BC_REQUEST_DEATH_NOTIFICATION death notification already set
init: sys_prop: permission denied uid:1000 name:ro.product.stb.stbid
init: sys_prop: permission denied uid:1000 name:ro.product.model
init: sys_prop: permission denied uid:1000 name:ro.product.manufacturer
cfg80211: Calling CRDA to update world regulatory domain
TLL901X: module init start
TLL901X: tilks9083 v1.2.0_0003.2016508
TLL901X: build time: Nov 6 2016 01:37:22
bFWReady == _FALSE call reset 8051...
########## padapter->registrypriv.bw_mode after 0x 1
TLL901X: tilk_init_ndev(wlan0)
TLL901X: tilk_init_ndev(p2p0)
usbcore: registered new interface driver tilks9083
TLL901X: module init ret=0
EXT4-fs (mmcblk0p22): recovery complete
EXT4-fs (mmcblk0p22): mounted filesystem with ordered data mode. Opts: share
==> _iol_efuse_patch_tll9083x
IPv6: ADDRCONF(NETDEV_UP): p2p0: link is not ready
IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
init: sys_prop: permission denied uid:10047 name:service.bootanim.exit
init: sys_prop: permission denied uid:10004 name:service.bootanim.exit
TLL901X: tilk_set_802_11_connet(wlan0) fw_state=0x00000008
TLL901X: start auth
TLL901X: auth success, start assoc
TLL901X: assoc success
IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
RsvdPageNum: 8
TLL901X: recv eapol packet
TLL901X: send eapol packet
TLL901X: recv eapol packet
TLL901X: send eapol packet
TLL901X: set pairwise key camid:4, addr:cc:34:29:6a:47:30, kid:0, type:AES
TLL901X: set group key camid:5, addr:cc:34:29:6a:47:30, kid:1, type:AES
init: untracked pid 1648 exited
init: untracked pid 2428 exited
init: untracked pid 2465 exited
init: untracked pid 2508 exited
init: sys_prop: permission denied uid:10035 name:service.bootanim.exit
|
|
/2 
雷达卡
发表于 2017-11-5 17:31
提升卡
置顶卡
变色卡
千斤顶
发表于 2017-11-7 09:43
