[red]福建移动魔百合MG101[/red]

fjjjq · 发表于 2017-1-10 08:19

用TTL代码一起跑不停如何解决  在.... in 110ms这个位置停一会儿，又开始循环，按。dddd按粘贴命令进去也是没反应
粘贴命令进去也是没反应  试过了

可QQ一起沟通下。508835308  看还有谁是这盒子的，或者已经破了。

RTL871X: <=== rtw_ips_pwr_down..................... in 110ms
RTL871X: cfg80211_rtw_scan(wlan0)
RTL871X: _rtw_pwr_wakeup call ips_leave....
RTL871X: ==>ips_leave cnts:4
RTL871X: ===>  rtw_ips_pwr_up..............
RTL871X: ===> ips_netdrv_open.........
RTL871X:  power-on :REG_SYS_CLKR 0x09=0x30. REG_CR 0x100=0xea.
RTL871X:  MAC has not been powered on yet.
RTL871X: SetHwReg8723B: bMacPwrCtrlOn=1
RTL871X: rtl8723b_FirmwareDownload(wlan0) tmp_ps=0
RTL871X: rtl8723b_FirmwareDownload fw: FW_NIC, size: 31952
RTL871X: rtl8723b_FirmwareDownload: fw_ver=27 fw_subver=0000 sig=0x5301, Month=10, Date=30, Hour=15, Minute=16
RTL871X: rtl8723b_FirmwareDownload(): Shift for fw header!
RTL871X: polling_fwdl_chksum: Checksum report OK! (1, 0ms), REG_MCUFWDL:0x00070605
RTL871X: _8051Reset8723: Finish
RTL871X: _FWFreeToGo: Polling FW ready OK! (420, 40ms), REG_MCUFWDL:0x000706c6
RTL871X: FWDL success. write_fw:1, 60ms
RTL871X:  <=== rtl8723b_FirmwareDownload()
RTL871X: fw download ok!
RTL871X: usb_AggSettingRxUpdate: RX Agg-USB mode, size=4KB, timeout=1024us
RTL871X: ===>phy_SwChnl8723B: Channel = 1
RTL871X: pDM_Odm TxPowerTrackControl = 1
RTL871X: pDM_Odm TxPowerTrackControl = 1
RTL871X: PHY_IQCalibrate_8723B =>path:B Restore TX IQK result fAIled
RTL871X: PHY_IQCalibrate_8723B =>path:B  Restore RX IQK result failed
RTL871X: rtl8723bu_hal_init in 1050ms
RTL871X: ===>phy_SwChnl8723B: Channel = 1
RTL871X: #### hw_var_set_opmode() -5215 iface_type(0) mode = 2 ####
RTL871X: Using the default RF gain.
RTL871X: rtl8723b_c2h_packet_handler: C2H, ID=9 seq=0 len=7
RTL871X: <===  rtw_ips_pwr_up.............. in 1080ms
RTL871X: nolinked power save leave
RTL871X: ==> ips_leave.....LED(0x00e28282)...
RTL871X: [HW_VAR_CHECK_TXBUF] no packet in tx packet buffer (0)
RTL871X: rtl8723b_c2h_packet_handler: C2H, ID=9 seq=1 len=7
RTL871X: rtl8723b_c2h_packet_handler: C2H, ID=9 seq=2 len=7
RTL871X: ===>phy_SwChnl8723B: Channel = 1
RTL871X: ===>phy_SwChnl8723B: Channel = 2
RTL871X: ===>phy_SwChnl8723B: Channel = 3
RTL871X: ===>phy_SwChnl8723B: Channel = 4
RTL871X: ===>phy_SwChnl8723B: Channel = 5
RTL871X: ===>phy_SwChnl8723B: Channel = 6
RTL871X: ===>phy_SwChnl8723B: Channel = 7
RTL871X: ===>phy_SwChnl8723B: Channel = 8
RTL871X: ===>phy_SwChnl8723B: Channel = 9
RTL871X: ===>phy_SwChnl8723B: Channel = 10
RTL871X: ===>phy_SwChnl8723B: Channel = 11
RTL871X: ===>phy_SwChnl8723B: Channel = 12
RTL871X: ===>phy_SwChnl8723B: Channel = 13
RTL871X: ===>phy_SwChnl8723B: Channel = 1
RTL871X: rtl8723b_c2h_packet_handler: C2H, ID=9 seq=3 len=7
RTL871X: survey done event(1d) band:0 for wlan0
RTL871X: rtw_indicate_scan_done(wlan0)
RTL871X: ==>rtw_ps_processor .fw_state(8)
RTL871X: ==>ips_enter cnts:5
RTL871X: nolinked power save enter
RTL871X: ===> rtw_ips_pwr_down...................
RTL871X: ====> rtw_ips_dev_unload...
RTL871X: usb_read_port_cancel
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_read_port_complete() RX Warning! bDriverStopped(False) OR bSurpriseRemoved(False)
RTL871X: usb_write_port_cancel
RTL871X: ==> rtl8723bu_hal_deinit
RTL871X: CardDisableRTL8723U(wlan0): bMacPwrCtrlOn=1
RTL871X: SetHwReg8723B: bMacPwrCtrlOn=0
RTL871X: <=== rtw_ips_pwr_down..................... in 110ms

人见百态 · 发表于 2017-1-10 11:27

帮你顶顶这个我也看不懂！

fjjjq · 发表于 2017-1-10 15:09

谢谢。。。沉底了。。。。

夹缝中流水 · 发表于 2017-2-10 13:05

虽不明，但觉厉！

fjjjq · 发表于 2017-2-14 15:06

已破解了。。。。

zukang · 发表于 2017-3-1 13:16

如何破解的呀？我的盒子是厦门移动咪咕mg101，急求破解方法，不方便回复的话也可私信我，谢谢！

bees678 · 发表于 2017-3-6 18:38

帮忙顶了我的也是

橙子焦糖酱 · 发表于 2017-3-15 17:08

fjjjq 发表于 2017-2-14 15:06
已破解了。。。。

怎么破解的

fjjjq · 发表于 2017-3-16 15:42

拆机TTL破解

磊磊磊 · 发表于 2017-4-27 19:25

想问一下九楼的，你是怎么破解的，有没有相关文章参考一下。

› 运营商IPTV / 有线电视 / 广电机顶盒 › 中国移动魔百盒

[red]福建移动魔百合MG101[/red]

[red]福建移动魔百合MG101[/red]

相关帖子

浏览过的版块

站长推荐 /1