有谁知道这九洲PTV8098（电信版）是什么芯片。
AC_ON
MIU0_DQS-OK
BIST0-
MIU0-1024_U
Relocation Offset is: 011d7000
[AT][MB][start ub][315]
U-Boot 2011.06 (Aug 15 2018 - 11:57:10)
[MIU INFO] miu opencreate instance at 559e9418 with private size 80 bytes at 559e9460
create instance at 559e94b8 with private size 52 bytes at 559e9500
uboot held at [557ddf60~56b00000],size=013220a0
CPU : Clippers
Board: BD_MST207C_D01A_S_CLIPPERS
DRAM: 875 MiB
Now running in RAM - U-Boot at: 55c00000
eMMC: HS200 200MHz
eMMC 7.28 GB [E8FFF8h]
In: serial
Out: serial
Err: serial
Net: No ethernet found.
MAC: 0xc: 0x49: 0x33: 0x58:0x2: 0x10
msIR_Initialize
[CPU INFO] cpu opencreate instance at 559f99c0 with private size 44 bytes at 559f9a08
CPUIoctl - MDrv_CMD_CPU_QueryClock
[UTOPIA INFO] close moduleNames[38]: MODULE_CPU
[AT][MBoot][Driver Init][557]
_Serial_Mac_Burn 1151
$$U
getenv macaddr [0C:49:33:58:02:10]
EMAC Mem Base:96834000
Rx buff:36834000
RBQP:36864000
Packet buffer:56a31b90
phy [0]=78c9
MAC Address 0C:49:33:58:02:10
Auto-Negotiation...
Link Status Speed:100 Full-duplex:1
word_ETH_CFG 803(Re)start EMAC...
Changelist: 24543697
============= set bootargs ===============
Hit any key to stop autoboot: 0
AC on
ovt_set_ethaddr command: mmc read.p 0x30000000 properties 0x400000
ovt_set_ethaddr properties name:mac value:0C:49:33:58:02:10
ovt_set_ethaddr command: mmc write.p 0x30000000 properties 0x400000 1
8192 blocks written: OK
Saving Environment to MMC...
Writing to MMC(0)... 128 blocks written: OK
128 blocks written: OK
done
ovt_set_ethaddr command: mmc read.p 0x30000000 properties 0x400000
ovt_set_ethaddr properties name:stb_id value:001004990108968017090C4933580210
ovt_set_ethaddr command: mmc write.p 0x30000000 properties 0x400000 1
8192 blocks written: OK
Saving Environment to MMC...
Writing to MMC(0)... 128 blocks written: OK
128 blocks written: OK
done
fore uup IRKey [0xff]
chip is NC:1
MsBoot getenv customer_board_id 5!!!
create instance at 559f9d70 with private size 256 bytes at 559f9db8
MDrv_PNL_Init u32PnlRiuBaseAddr = 1f200000
MDrv_PNL_Init u32PMRiuBaseAddr = 1f000000
PNL:[MDrv_PNL_SetPanelType][613]
[_MDrv_PNL_Init_LPLL][323]pstPanelInitData->u16Width=1280, pstPanelInitData->u16Height=720
[_MDrv_PNL_Init_LPLL][325]u16HTotal=1980,u16VTotal=750,pstPanelInitData->u16HTotal=1980,pstPanelInitData->u16VTotal=750, u16DefaultVFreq=500
[_MDrv_PNL_Init_Output_Dclk][369]pstPanelInitData->u16Width=1280, pstPanelInitData->u16Height=720
[_MDrv_PNL_Init_Output_Dclk][371]u16HTotal=1980,u16VTotal=750,pstPanelInitData->u16HTotal=1980,pstPanelInitData->u16VTotal=750, u16DefaultVFreq=500
PNL:CalculateLPLLSETbyDClk u32KHz = 742500000, u64DefaultLdHz = 742500000
PNL:CalculateLPLLSETbyDClk u32LpllSet = 3531df
[MApi_XC_MLG_GetStatus, 1603]No instance existed, please get an instance by calling MApi_XC_Init() first
msHdmitx_Disp_Init
create instance at 559f9ec0 with private size 1720 bytes at 559f9f08
[XC,Version]
no need to patchcreate instance at 559fab08 with private size 80 bytes at 559fab50
Rx Support HDMI mode!
msdbg REG_PKT_AVI_1_09=5850, 0x2008=c2, bIs420=0
msdbg bIsMSO9280NC = 1, bIsHDMI20=0, b222MHz=0, idx=5, cd_val=0
shift -8 pixels in PAL mode
Create Dolby single part name task failed!![Hal_VE_Set_PreHSD][1817] ERROR!!! HVSD H input = 0, HVSD H output = 720
[Hal_VE_Set_PreVSD][1991] ERROR!!! HVSD V input = 0, HVSD V output = 576
[Hal_VE_EnableDI][2099] bEnable = 0, bIsDNR2VE = 0
create instance at 559faba8 with private size 304 bytes at 559fabf0
[AT][MB][JPD Decode][7376]
[UTOPIA INFO] close moduleNames[35]: MODULE_NJPEG_EX
reproduceRate:168430090
create instance at 559faba8 with private size 132280 bytes at 559fabf0
[GOP INFO] gop opencreate instance at 55a1b0b0 with private size 6912 bytes at 55a1b0f8
create instance at 55a1cc00 with private size 1720 bytes at 55a1cc48
[AT][MB][Show Logo][7440]
In HAL_AUDIO_SetDspBaseAddr, line(4350), u8Index(0x0), u32Bin_Base_Address(0x0), u32Mad_Base_Buffer_Adr(0x37bb0000)
In HAL_AUDIO_SetDspBaseAddr, line(4350), u8Index(0x1), u32Bin_Base_Address(0x0), u32Mad_Base_Buffer_Adr(0x37930000)
In HAL_AUDIO_SetDspBaseAddr, line(4350), u8Index(0x2), u32Bin_Base_Address(0x0), u32Mad_Base_Buffer_Adr(0x37130000)
[
|
网站导航
发表于 2019-4-12 19:39
收藏
淘帖
顶一个
踩
提升卡
置顶卡
变色卡
千斤顶
znds.com 