海兔烧写错误信息:
Bootrom start
Boot Media: NAND
##############################################
Decrypt auxiliary code ...OK

lsadc voltage min: 000002FB, max: 00000306, aver: 000002FF, index: 00000001

Failed to send the boot data.
1. The system fails to run properly due to an error in boot code compilation.
2. If the secure boot function is disabled and boot rootkey is set for the OEM, the boot image is encrypted, but the boot rootkey used for encrypting the boot is different from the boot rootkey burnt to the OTP.
Timeout error.
3. The chip OTP is set to forcibly decrypt the boot image. However, the boot is not correctly encrypted.
4. The board DDR is faulty.
5. The boot code does not support the type of the flash memory to be burnt. If the boot print function is enabled, you can view the printing information through the serial port, showing that the current flash memory type is not supported.
Failed to send the head frame.

Enter boot auxiliary code

Auxiliary code - v1.00
DDR code - V1.1.2.1 20171011
Build: Sep 11 2018 - 19:55:16

Reg Version:  v1.5.2`
Reg Time:     2018/10/10 16:14:27
Reg Name:     hi3798m3hdms1_hi3798mv300h_DDR3-1866_1GB_16bitx2_2layers_cm.re5
请检查当前programmer或boot是否与单板匹配。
Failed to download fastboot!

如果是刷错了eMMC固件的我没的招。
因为海兔无法烧写

用强刷包短接闪存5.6脚试试

hongy 发表于 2021-3-10 00:21
给你烧录包也不见得你会用，nand比较难搞

关键是没有，有的话倒是可以学习下。

给你烧录包也不见得你会用，nand比较难搞

陈长兵 发表于 2021-3-9 18:21
引导没了

这款盒子很奇怪，找了N多固件都没有用。

引导没了

xiaolu8521855 发表于 2021-3-9 10:49
可以救用海思烧录

问题是没有救砖包或原厂备份。

跪求广电U点盒E900-S(3798mv310)原厂备份