B860A主板连接TTL，ping不通
本帖最后由 智能小柠檬 于 2023-3-6 15:09 编辑B860A不带V主板连接TTL，SecureCRT设置好，快速连接中流量控制三个都不勾选，电脑主机关闭了防火墙，ping不通。
按照这个操作：
m8m2_n200_v1#
输入
setenv ipaddr 192.168.0.134（设置盒子的IP地址，改与你网络相同的网段，如192.168.1.X）
setenv serverip 192.168.0.101（设置TFTP服务器地址，改与你电脑本地连接的IP地址，如192.168.1.X）
setenv gatewayip 192.168.0.1 （设置网关，改与你网络的网关，如192.168.1.1）
ping一下网络是否正常：
ping 192.168.0.101
ping 192.168.0.134
输出结果：
m8m2_n200_v1#ping 192.168.0.101
Amlogic Ethernet Init
Success: reset mac OK!(0)
ETH PHY hardware reset OK
find net phy id=0x1cc816, phyad=0
set_mac_mode(0)
final_addr: 0x3ffec000-0x3ffec600
Ethernet reset OK
MAC address is 00:15:18:01:81:31
phy auto link failed
half duplex
10m
Using Meson_Ethernet device
phy auto link failed
phy auto link failed
phy auto link failed
phy auto link failed
phy auto link failed
ping failed; host 192.168.0.101 is not alive
m8m2_n200_v1#ping 192.168.0.134
Using Meson_Ethernet device
phy auto link failed
phy auto link failed
phy auto link failed
phy auto link failed
phy auto link failed
ping failed; host 192.168.0.134 is not alive
m8m2_n200_v1#
打开盒子ADB,然后用ZTE工具箱 在“m8m2_n200_v1#”下能打开ADB么？
页:
[1]
